A1 Quick Setup — Audioengine Skip to Content

A1 Quick Setup

Step 1: Connect the included speaker wire from the A1 left (powered) speaker to the right (passive) speaker, observing proper polarity to each speaker connector.

Step 2: Verify that the volume/power knob on the rear panel of the left speaker is in the OFF position by rotating the knob until it clicks off..

Step 3: Connect the cable from the external power supply to the A1 left speaker rear panel.

Step 4: Connect the Ac power cord to the A1 left speaker rear panel and plug the other end of the cable into a functioning power outlet.

Wireless Connection

Step 1: Turn power on via the rear panel volume/power knob.
A1 will automatically go into Bluetooth "pair mode" and the Pair button on the rear panel will start flashing.

Step 2:: On your device (phone, tablet, computer, etc), turn on Bluetooth and go to Bluetooth preferences.

Step 3: Select "Audioengine ONE" to pair and connect. The Pair indicator on the A1 rear panel should be solid.

Step 4: Play your music and adjust volume levels on A1 and your device.

Step 5: To add additional devices put A1 back into pair mode by disconnecting A1 from your device or by pressing and holding the Pair button on the A1 rear panel until the pair indicator starts flashing. Repeat steps 2 & 3 to connect another device.

A1 can wirelessly connect to only one device at a time, however it will pair with and remember up to 6 different devices.

Wired Connection

Step 1: Connect an audio cable between your device and the input on the A1 rear panel.

Step 2: Play your music and adjust the volume on the speakers and your device to the desired listening levels.


For the full setup guide, download the attached PDF: 

A1 Quick Start Guide

View support page